Great Start!

All the parts for both pedal divisions have been measured and drawn onto various pieces of wood. I did not have enough time today to actually cut them out. For the top and bottom base for this division, I went "old school" and got out my old drafting equipment and drew the piece the same way I drew it in SolidWorks. I just pray that, when everything gets cut out, everything fits together!

I also measured and cut to length most of the pipes for the Oberwerk division. With the stock I had, a few were cut for the Ruckpositiv division. Below is what I have for the Oberwerk. The very center pipe will be above the console. It is 1/2" in diameter and 10" high.

It is hard to tell in this image, but the mouths are indicated by the lines from the bottom of the pipe.
I have a lot of dowel's to turn down in the lathe!